Setup PDEG to comunicate whit Pharos LPC using UDP  


New Member Customer
Joined: 3 months ago
Posts: 1
January 10, 2020 20:19  

Any one that can tell me how to setup the Dynalig PDEG to send button press from the DyNet (spure) out on TCP (Trunk) as UDP.

Topic Tags
Member Admin
Joined: 2 years ago
Posts: 1
January 13, 2020 20:09  

Hi Benjamin,

You can use wizard for that and setup as Dynet Translation Ethernet Gateway (right click on the device and choose Bridge Configuration Wizard). Set your IP, Trunk Connection, Spur Connection with ports and finally add either physical or logical range with offset. When you finish, it will allow that Spur to send/receive messages to/from the Ethernet. This has to be done for every PDEG on the trunk.

I don't really have experience with Pharos but would assume that this should work on the Dynet side. I believe you need to setup Pharos too but not sure. I can try to find out from the factory if you don't get this right.

I hope this helps. 🙂




Please Login or Register